Share some CCNA Routing and Switching 200-125 exam questions and answers below.
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Answer: C
Two hosts are attached to a switch with the default configuration.
Which statement about the configuration is true?
A. IP routing must be enabled to allow the two hosts to communicate.
B. The two hosts are in the same broadcast domain.
C. The switch must be configured with a VLAN to allow the two hosts to communicate.
D. Port security prevents the hosts from connecting to the switch.
Answer: B
How to create a trunk port and allow VLAN 20? (Choose Three.)
A. switchport trunk encapsulation dot1q
B. switchport mode trunk
C. switchport trunk allowed vlan 20
D. switchport trunk native vlan 20
Answer: ABC
For what two purposes does the Ethernet protocol use physical addresses? (Choose two.)
A. to uniquely identify devices at Layer 2
B. to allow communication with devices on a different network
C. to differentiate a Layer 2 frame from a Layer 3 packet
D. to establish a priority system to determine which device gets to transmit first
E. to allow communication between different devices on the same network
F. to allow detection of a remote device when its physical address is unknown
Answer: A,E
Which command can you enter to verify that a BGP connection to a remote device is established?
A. show ip bgp summary
B. show ip community-list
C. show ip bgp paths
D. show ip route
Answer: A
Which mode is compatible with Trunk, Access, and desirable ports?
A. Trunk Ports
B. Access Ports
C. Dynamic Auto
D. Dynamic Desirable
Answer: C
A network administrator is verifying the configuration of a newly installed host by establishing an FTP connection to a remote server. What is the highest layer of the protocol stack that the network administrator is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
Answer: A
A router has two Fast Ethernet interfaces and needs to connect to four VLANs in the local network. How can you accomplish this task, using the fewest physical interfaces and without decreasing network performance?
A. Use a hub to connect the four VLANS with a Fast Ethernet interface on the router.
B. Add a second router to handle the VLAN traffic.
C. Add two more Fast Ethernet interfaces.
D. Implement a router-on-a-stick configuration.
Answer: D
A lot of people in the discussion said that such a good certificate is difficult to pass and actually the pass rate is quite low. Not having done any efforts of preparation is not easy to pass, after all, Cisco 200-125 questions and answers pdf require excellent expertise. Our Passtcert is a website that can provide you with a shortcut to pass Cisco certification 200-125 exam.
It is an undeniable fact. Through this we can know that Passtcert Cisco 200-125 questions and answers pdf can brought help to the candidates. And our price is absolutely reasonable and suitable for each of the candidates who participating in the IT certification exams.Cisco 200-125 certification exam will definitely lead you to a better career prospects. CCNA Routing and Switching 200-125 exam can not only validate your skills but also prove your expertise.
No comments:
Post a Comment